Misc Links
Forum Archive
News Archive
File DB
 

PrimoChill Dual Bay Reservoir Review
Posted by Red Squirrel on February 13th 2004



Once you have all the hoses connected you are ready to start filling your system. We use a funnel to make sure all the water gets into the reservoir, and not onto the system, but this is not the only way to fill the reservoir. The fill and bleed process is quite simple. You fill the reservoir and prime the pump. Once your pump is primed you can fire it up; just be ready to put some more water into the reservoir as the pump starts filling the system. Simply keep adding water until there is no more air left in the system. The exact process for this will depend upon your water cooling configuration.

View article at GruntvillE.com



(Due to past abuse from spammers you must be a registered forum member to post comments, and must be logged in)


corner image

This site best viewed in a W3C standard browser at 800*600 or higher
Site design by Red Squirrel | Contact
© Copyright 2019 Ryan Auclair/IceTeks, All rights reserved